HP B-series Fabric OS 7.1.0_blv Release Notes (5697-2827, September 2013)

Table 2 Fabric OS 7.1.0 closed defects (continued)
SolutionClosed defect summary
Fixed in Fabric OS 7.1.0.
Fixed in Fabric OS 7.1.0.Switch panic occurs while running supportsave with 4
Gb/s blades.
Fixed in Fabric OS 7.1.0.CRC w/ good EOF occur on ports 1/24 and 1/74 on an
HP DC SAN Director 64-port 8Gb FC Blade in an HP
SN8000B SAN Director.
Fixed in Fabric OS 7.1.0.The portledtest --npass variable default is not
configured correctly.
Fixed in Fabric OS 7.1.0.Open Systems Tape Pipelining fails after an upgrade to
Fabric OS 7.0.1b.
Fixed in Fabric OS 7.1.0.FCIP tunnel bounces due to DRAM2 allocate failures or
BLS-5024 event.
Fixed in Fabric OS 7.1.0.LUN discovery fails due to busy HP DC Switch Encryption
FC Blade processor.
Fixed in Fabric OS 7.1.0.FICON tape performance is being throttled on backups
from a mainframe across two FCIP tunnels to a remote disk
library at DR site.
Fixed in Fabric OS 7.1.0.As a result of a switch going unreachable, HA Failover
was performed from Slot6 to Slot7. Slot7 then experienced
a panic, rebooted, and an outage occurred.
Fixed in Fabric OS 7.1.0.Access Gateway does not clean up frame exchange
properly if FLOGI/FDISC comes in from different ports
together with same exchange ID (OX-ID).
Workaround prior to upgrade:After power cycling an HP SN8000B SAN Director, the
HP SN8000B 16Gb 32-port Fibre Channel Blade is set to
Faulty-51.
Power cycle the blade or the chassis.
Fixed in Fabric OS 7.1.0.
Fixed in Fabric OS 7.1.0.The Topologyshow command is not correct on the HP
2408 FCoE Convergerd Network Switch with Port-based
routing.
Fabric OS 7.1.0a fixes
Table 3 (page 36) lists defects closed in the Fabric OS 7.1.0 firmware release.
Table 3 Fabric OS 7.1.0a closed defects
SolutionClosed defect summary
Fixed in Fabric OS 7.1.0a.CRC with good EOF errors detected on the HP DC SAN
Backbone Director with an HP SAN Director 48-port 8Gb
FC Blade insertd in slot 3 on ports 3/42 <-> 8/139.
Fixed in Fabric OS 7.1.0a.On an HP DC04 SAN Director, backend CRC errors are
detected on core blade ports 3/56 connecting the HP SAN
Director 32-port 8Gb FC Blade.
Workaround prior to upgrade:The Error log content is being cleared of prior messages
when migrating to Fabric OS 7.1.0.
Supportsave can be used to save and retain the error
log contents if the supportsave is successfully executed
prior to the firmwaredownload upgrade to Fabric OS
7.1.0.
Fixed in Fabric OS 7.1.0a.
36