HP B-series Fabric OS 7.1.0_blv Release Notes (5697-2827, September 2013)

Table 2 Fabric OS 7.1.0 closed defects (continued)
SolutionClosed defect summary
Workaround prior to upgrade:Detected termination of Name Server Daemon (NSD)
during CLI nodefind execution.
Avoid executing the nodefind CLI command under the
noted conditions.
Fixed in Fabric OS 7.1.0.
Fixed in Fabric OS 7.1.0.The "CustomizeColumns" tab under "SwitchEvents" have
three greyed out options in Webtools.
Workaround prior to upgrade:An SW.mib syntax error prevents loading in HP NNMi
9.10 patch 2.
Manually edit the SW.mib file.
Fixed in Fabric OS 7.1.0.
Workaround prior to upgrade:A Fabric OS memory leak is triggered through Storage
Application Services with a misconfigured zone.
Remove the frame redirect and recreate the binding.
Fixed in Fabric OS 7.1.0.
Fixed in Fabric OS 7.1.0.Running the perfcfgrestore command after the
perfcfgsave command may not restore all
PerfEEMonitors.
Fixed in Fabric OS 7.1.0.An HA Failover, HAReboot or firmwaredownload may
cause unused ports with an ASIC register being zeroed
out.
Fixed in Fabric OS 7.1.0.Fabric LOGO is not clearing out the stale FCID logins on
Access gateway. Users see "duplicate ALPA" error
messages from the fabric.
Workaround prior to upgrade:Upgrade to Fabric OS 6.4.3x/v7.0.2x/7.0.1a or later
results in errors on ports that have media validation issues.
To avoid the issue prior to upgrading the firmware: issue
an sfpshow –f to every port and then run hasyncstop
/ hasyncstart;
Or:
To recover after upgrade: issue sfpshow -f <port#>
to every port and then run hasyncstop; hasyncstart;
and portdisable/enable problem ports.
Fixed in Fabric OS 7.1.0.
Fixed in Fabric OS 7.1.0.A CP panic occurs when running the agshow command
and there are stale AG entries.
Workaround prior to upgrade:Rekey of a disk crypto target LUN is stuck.
Toggling the target port will cause rekeying to be retried.
Fixed in Fabric OS 7.1.0.
Fixed in Fabric OS 7.1.0.During DWDM link failover, OLS is experienced with
LOS_TOV enabled.
Fixed in Fabric OS 7.1.0.A 5460 reboots whenever portloopbacktest is run
with the port speed configuration set to 8 Gb/s.
Workaround prior to upgrade:A switch goes into a reboot loop after loading the config
with an SSL certificate file entry and there is no certificate
on the switch.
Delete the csr file in /etc/fabos/certs/sw0 and then reboot
the switch.
Fixed in Fabric OS 7.1.0.
Workaround prior to upgrade:Missing device end reported by MVS host running FICON
Tape emulation.
Turn off FICON tape emulation.
Fabric OS 7.1.0 fixes 35