Brocade Network Advisor Migration Guide v11.1x (53-1002321-01, May 2011)
Table Of Contents
- Brocade Network Advisor
- In this guide
- Feature support
- Network Advisor packages
- Management server and client ports
- System requirements
- Migration paths
- Pre-migration requirements
- Installing the application
- Cross operating system migration
- DCFM migration
- Network Advisor migration
- Network Advisor 11.0.X to 11.1.X command mapping
- Cross flavor migration
- Unsupported server migration
- Configuring an explicit server IP address
- IPv6 troubleshooting
- Syslog troubleshooting
- Uninstallation
Brocade Network Advisor Migration Guide 69 of 82
53-1002321-01
Network Advisor migration
12. Complete the following steps on the Start Server screen.
FIGURE 32 Start Server screen
a. (SAN with SMI Agent) Select the Start SMI Agent check box, if necessary.
b. (SAN with SMI Agent) Select the Start SLP check box, if necessary.
c. Select the Start Client check box, if necessary.
d. Click Finish.
After all of the services (Server, SLP, SMI Agent and Client) are started, the Log In dialog box displays.
13. Enter your user name and password.
The defaults are Administrator and password, respectively. If you migrated from a previous release, your
username and password do not change.
14. Click Login.
15. Click OK on the Network Advisor Login Banner.
NOTE
For ESX hosts discovered in 10.4.X or 11.0.X, the VM properties of those ESX hosts are purged upon migration
to 11.1.X.