Brocade Fabric OS Message Reference guide v6.2.0 (53-1001157-01, April 2009)

592 Fabric OS Message Reference
53-1001157-01
SULB-1035
100
Recommended
Action
Reboot the switch. This will cause the internal image to be relocated again. Use the
firmwareDownloadStatus command to monitor the progress. If the problem persists, contact your
switch service provider.
Severity ERROR
SULB-1035
Message AUDIT, <timestamp>, [SULB-1035], ERROR, FIRMWARE, <event-initiator-details>,
<event-location>, , An error has occurred relocation of the internal image.
Probable Cause Indicates an error has occurred during the relocation of the internal image. The error may be
caused by inconsistent internal firmware image. It may also be caused by the internal Ethernet or
persistent storage hardware failure.
Recommended
Action
Reset the switch. This will cause the internal image to be relocated again. If the problem persists,
contact your switch service provider.
Severity ERROR
SULB-1037
Message AUDIT, <timestamp>, [SULB-1037], ERROR, FIRMWARE, <event-initiator-details>,
<event-location>, , HCL failed. Reboot the switch manually using the reboot
command. However, it will disrupt the FC traffic.
Probable Cause Indicates HCL has failed. Many reasons, such as domain not confirmed, can cause this failure.
Recommended
Action
Run the reboot command to reboot the switch manually.
Severity ERROR