Brocade Fabric OS Message Reference guide v6.2.0 (53-1001157-01, April 2009)

Fabric OS Message Reference 581
53-1001157-01
Chapter
100
AUDIT SULB System Messages
SULB-1001
Message AUDIT, <timestamp>, [SULB-1001], WARNING, FIRMWARE, <event-initiator-details>,
<event-location>, , Firmwaredownload command has started.
Probable Cause Indicates the firmwareDownload command has been entered. This process should take
approximately 17 minutes. The process is set to time out after 30 minutes.
Recommended
Action
No action is required. Allow the firmwareDownload command to continue without disruption. Do
not fail over or power down the system during firmware upgrade.
Run the firmwareDownloadStatus command for more information.
Severity WARNING
SULB-1002
Message AUDIT, <timestamp>, [SULB-1002], INFO, FIRMWARE, <event-initiator-details>,
<event-location>, , Firmwaredownload command has completed successfully.
Probable Cause Indicates the firmwareDownload command has completed successfully and switch firmware has
been updated.
Recommended
Action
No action is required. The firmwareDownload command has completed as expected.
Run the firmwareDownloadStatus command for more information. Run the firmwareShow
command to verify the firmware versions.
Severity INFO
SULB-1003
Message AUDIT, <timestamp>, [SULB-1003], INFO, FIRMWARE, <event-initiator-details>,
<event-location>, , Firmwarecommit has started.
Probable Cause Indicates that the firmwareCommit command has been entered.
Recommended
Action
No action is required. Run the firmwareDownloadStatus command for more information.
Severity INFO