Brocade Fabric OS Message Reference guide v6.2.0 (53-1001157-01, April 2009)

Fabric OS Message Reference 457
53-1001157-01
SEC-1311
75
Severity INFO
SEC-1311
Message <timestamp>, [SEC-1311], <sequence-number>,, ERROR, <system-name>, Security mode
cannot be enabled because one or more of the password policies is not set to
default value.
Probable Cause Indicates the security enable failed on the fabric because one or more switches in the fabric have
password policies that are not set to the default value.
Recommended
Action
Verify the security event was planned.
If the security event was planned, run the passwdCfg --setDefault command on each switch in the
fabric to set the password policies to the default value. Then verify with passwdCfg --show that
password policies are set to the default values on all switches and retry the secModeEnable
command.
Severity ERROR
SEC-1312
Message <timestamp>, [SEC-1312], <sequence-number>,, INFO, <system-name>, <MESG Message>.
Probable Cause Indicates the passwdCfg parameters changed.
Recommended
Action
Verify the security event was planned. If the security event was planned, no action is required. If the
security event was not planned, take appropriate action as defined by your enterprise security
policy.
Severity INFO
SEC-1313
Message <timestamp>, [SEC-1313], <sequence-number>,, INFO, <system-name>, The passwdcfg
parameters were set to default values.
Probable Cause Indicates the passwdCfg parameters were set to default values.
Recommended
Action
Verify the security event was planned. If the security event was planned, no action is required. If the
security event was not planned, take appropriate action as defined by your enterprise security
policy.
Severity INFO
SEC-1314
Message <timestamp>, [SEC-1314], <sequence-number>,, ERROR, <system-name>, Reading <IP
Address Description > IP address from EM failed.