Brocade Fabric OS Message Reference guide v6.2.0 (53-1001157-01, April 2009)

Fabric OS Message Reference 423
53-1001157-01
SEC-1072
75
Severity ERROR
SEC-1072
Message <timestamp>, [SEC-1072], <sequence-number>,, ERROR, <system-name>, <Policy
type>
Policy List is Empty!
Probable Cause Indicates the specific policy type is empty. The security database is corrupted for unknown reasons.
Recommended
Action
Run supportFtp (as needed) to set up automatic FTP transfers; then run the supportSave command
and contact your switch service provider.
Severity ERROR
SEC-1073
Message <timestamp>, [SEC-1073], <sequence-number>,, ERROR, <system-name>, No FCS policy
in list!
Probable Cause Indicates the specific policy type is empty. The security database is corrupted for unknown reasons.
Recommended
Action
Run supportFtp (as needed) to set up automatic FTP transfers; then run the supportSave command
and contact your switch service provider.
Severity ERROR
SEC-1074
Message <timestamp>, [SEC-1074], <sequence-number>,, ERROR, <system-name>, Cannot execute
the command on this switch. Please check the secure mode and FCS status.
Probable Cause Indicates a security command was run on a switch that is not allowed to run it either because it is in
non-secure mode or because it does not have the required fabric configuration server (FCS)
privilege.
Recommended
Action
If a security operation that is not allowed in non-secure mode is attempted, do not perform the
operation in non-secure mode. In secure mode, run the command from a switch that has required
privilege, that is, either a backup FCS or primary FCS.
Severity ERROR
SEC-1075
Message <timestamp>, [SEC-1075], <sequence-number>,, ERROR, <system-name>, Fail to
<operation> new policy set on all switches.