Brocade Fabric OS Message Reference guide v6.2.0 (53-1001157-01, April 2009)

Fabric OS Message Reference 421
53-1001157-01
SEC-1057
75
SEC-1057
Message <timestamp>, [SEC-1057], <sequence-number>,, ERROR, <system-name>, No change.
Both positions are the same.
Probable Cause Indicates there has been a corruption during the distribution of the security database. This can only
occur when the primary fabric configuration server (FCS) is distributing the security database to the
other switches in the fabric and local validation finds that there is an error in the security database.
This is a rare occurrence.
Recommended
Action
Run the secFabricShow command to verify that the fabric is still consistent. All the switches should
be in the ready state. If a switch is in the error state, the database might not be correctly updated
for that specific switch.
Severity ERROR
SEC-1059
Message <timestamp>, [SEC-1059], <sequence-number>,, ERROR, <system-name>, Fail to
<operation, e.g., save, delete, etc.,> <named item> to flash.
Probable Cause Indicates the operation failed when writing to flash.
Recommended
Action
Run the supportFtp - e command to FTP files from the switch and remove them from the flash.
Severity ERROR
SEC-1062
Message <timestamp>, [SEC-1062], <sequence-number>,, ERROR, <system-name>, Invalid number
of Domains in Domain List.
Probable Cause Indicates that either no domains or domains more than the maximum number supported are
specified.
Recommended
Action
Enter the correct number of domains.
Severity ERROR
SEC-1063
Message <timestamp>, [SEC-1063], <sequence-number>,, ERROR, <system-name>, Failed to
reset statistics.
Probable Cause Indicates that either the type or domains specified are invalid.
Recommended
Action
Enter valid input.