Brocade Fabric OS Message Reference guide v6.2.0 (53-1001157-01, April 2009)

Fabric OS Message Reference 299
53-1001157-01
HAM-1007
36
Recommended
Action
The standby CP will take over and reset the active CP. The system will be non-redundant as the
standby becomes the active CP.
Severity CRITICAL
HAM-1007
Message <timestamp>, [HAM-1007], <sequence-number>,, CRITICAL, <system-name>,Need to
reboot the system for recovery, reason: <reason name>.
Probable Cause Indicates that the system in current condition needs to be rebooted to achieve a reliable recovery.
The reasons can be that the standby CP is not ready when failover occurred, failover happened
when the last LS transaction is incomplete, or the system failed when a timeout occurred at certain
stage or cold/warm recovery failed. If auto-reboot is enabled, the system will automatically reboot
itself. Otherwise you need to manually reboot it.
Recommended
Action
For a reliable recovery, reboot the system manually if auto-reboot recovery is disabled.
Severity CRITICAL
HAM-1008
Message <timestamp>, [HAM-1008], <sequence-number>,, CRITICAL, <system-name>,Rebooting
the system for recovery - auto-reboot is enabled.
Probable Cause Recovery by reboot is enabled, the system will automatically reboot itself. This follows if the event
logged in 1007 has happened and auto-reboot is enabled.
Recommended
Action
No action is required.
Severity CRITICAL
HAM-1009
Message <timestamp>, [HAM-1009], <sequence-number>,, CRITICAL, <system-name>,Need to
MANUALLY REBOOT the system for recovery - auto-reboot is disabled.
Probable Cause Recovery by reboot is disabled, the system needs to be manually rebooted for recovery. This follows
if the event logged in 1007 has happened and auto-reboot is disabled.
Recommended
Action
Reboot the whole system manually to recover.
Severity CRITICAL