Brocade Fabric OS Message Reference guide v6.2.0 (53-1001157-01, April 2009)

262 Fabric OS Message Reference
53-1001157-01
FW-1306
35
FW-1306
Message <timestamp>, [FW-1306], <sequence-number>,, WARNING, <system-name>, <Label>, is
above high boundary(High=<High value>, Low=<Low value>). Current value is <Value>
<Unit>.
Probable Cause Indicates that the number of application programming interface (API) violations has risen above the
high boundary. API violations indicate that an API connection request has been received from an
unauthorized IP address. The simple network management protocol policy (SNMP_POLICY)
contains a list of internet protocol (IP) addresses that are authorized to establish API connections
to switches in the fabric.
Recommended
Action
Run the errShow command to determine the IP address that sent the request. Responses to
security-class messages depend on user policies. Consult your security administrator for response
strategies and policies.
Severity WARNING
FW-1307
Message <timestamp>, [FW-1307], <sequence-number>,, INFO, <system-name>, <Label>, is
between high and low boundaries(High=<High value>, Low=<Low value>). Current value
is <Value> <Unit>.
Probable Cause Indicates that the number of application programming interface (API) violations has changed from
a value outside of the acceptable range to a value within the acceptable range. API violations
indicate that an API connection request has been received from an unauthorized IP address. The
simple network management protocol policy (SNMP_POLICY) contains a list of internet protocol (IP)
addresses that are authorized to establish API connections to switches in the fabric.
Recommended
Action
No action is required.
Severity INFO
FW-1308
Message <timestamp>, [FW-1308], <sequence-number>,, INFO, <system-name>, <Label>, value
has changed(High=<High value>, Low=<Low value>). Current value is <Value> <Unit>.
Probable Cause Indicates that the number of simple network management protocol read (RSNMP) violations has
changed. RSNMP violations indicate that an SNMP “get” operation request has been received from
an unauthorized IP address.
Recommended
Action
Run the errShow command to determine the IP address that sent the request. Responses to
security-class messages depend on user policies. Consult your security administrator for response
strategies and policies.
Severity INFO