Brocade Fabric OS Message Reference guide v6.2.0 (53-1001157-01, April 2009)

178 Fabric OS Message Reference

53-1001157-01

FCR-1083

Message <timestamp>, [FCR-1083], <sequence-number>,, WARNING, <system-name>, The resume

message is rejected by the domain <Domain>.

Probable Cause During the Coordinated HotCode protocol, a switch in the fabric has rejected the pause message

which prevented the protocol from completing. Any data traffic disruption observed during the

firmware download may have been due to the rejected resume message.

Recommended

Action

Severity WARNING

FCR-1084

Message <timestamp>, [FCR-1084], <sequence-number>,, WARNING, <system-name>, The resume

retry count is exhausted for the domain <Domain>.

Probable Cause During the Coordinated HotCode protocol, a switch in the fabric did not accept the resume

message which prevented the protocol from completing. Any data traffic disruption observed

during the firmware download may have been due to this issue.

Recommended

Action

Severity WARNING

FCR-1085

Message <timestamp>, [FCR-1085], <sequence-number>,, ERROR, <system-name>, HA sync lost

as remote CP does not support FCR based matrix.

Probable Cause Indicates that the remote control processor (CP) has older firmware, which does not support FCR-

based matrix while the local CP has the feature enabled. This is causing the loss of the

high-availability (HA) synchronization.

Recommended

Action

Disable FCR-based matrix or upgrade the remote CP.

Severity ERROR

FCR-1086

Message <timestamp>, [FCR-1086], <sequence-number>,, ERROR, <system-name>, HA sync lost

as remote CP does not support Condor2 based EX_ports.

Probable Cause Indicates that the remote control processor (CP) has older firmware, which does not support

Condor-based EX_ port. This is causing the loss of the high-availability (HA) synchronization.