Brocade Fabric OS Message Reference guide v6.2.0 (53-1001157-01, April 2009)

120 Fabric OS Message Reference
53-1001157-01
EM-1065
17
Probable Cause Indicates the blade is being powered off because a hardware (HW) application specific integrated
circuit (ASIC) ERROR was detected, and you have selected to power off the problem blade when
such a condition occurred.
Recommended
Action
Contact support.
Severity CRITICAL
EM-1065
Message <timestamp>, [EM-1065], <sequence-number>,, CRITICAL, <system-name>, SSAS
Virtualization Services are not available due to incompatibility between the FOS
and SAS versions<Slot number or blank for single board systems>.
Probable Cause Indicates the version of either the control processor firmware (CFOS) or the blade processor
firmware (BFOS) is not compatible with the Storage Application Services (SAS) or other application
firmware versions.
Recommended
Action
Upgrade the FOS firmware or the SAS firmware with the firmwareDownload command. Refer to the
release notes for a compatible version of firmware.
Severity CRITICAL
EM-1066
Message <timestamp>, [EM-1066], <sequence-number>,, INFO, <system-name>, SAS
Virtualization Services are now available <Slot number or blank for single board
systems>.
Probable Cause Indicates the previously incompatible Fabric OS or Storage Application Services (SAS) firmware has
been upgraded and is now compatible.
Recommended
Action
No action is required.
Severity INFO
EM-1067
Message <timestamp>, [EM-1067], <sequence-number>,, WARNING, <system-name>, Stopping
synchronization of the system due to version incompatibility with standby CP.
Probable Cause Indicates that the software version on the standby CP is not compatible with this software version.
Recommended
Action
Upgrade the software on the standby CP or downgrade the software on this CP.
Severity WARNING