Brocade Fabric OS Command Reference Manual v6.2.0 (53-1001186-01, April 2009)

808 Fabric OS Command Reference

53-1001186-01

turboRamTest

Performs a turbo SRAM test of ASIC chips.

Synopsis turboramtest [--slot slotnumber][-passcnt count]

Description This command verifies the on chip SRAM located using the turbo-RAM BIST circuitry. The BIST

controller is able to perform the SRAM write and read operation at a much faster rate than the PCI

operation.

This test is supported on all 4 G and 8 G platforms.

Note The execution of this command is subject to Virtual Fabric or Admin Domain restrictions that may

be in place. Refer to chapter 1, "Using Fabric OS commands" and Appendix A, "Command

Availability" for details.

Operands This command has the following optional operands:

--slot slotnumber Specifies the slot number on which the diagnostic operates. All blade ports in

the specified slot are tested. This operand is optional. The default value is 0

and operates on fixed port count products.

-passcnt count Specifies the number of times to perform this test. This operand is optional.

The default value is 1.

Examples To run the SRAM test with two passes:

switch:admin> turboramtest -passcnt 2

Test Complete: turboramtest Pass 2 of 2

Duration 0 hr, 0 min & 1 sec (0:0:0:417).

passed.