Brocade Fabric OS Command Reference Manual v6.2.0 (53-1001186-01, April 2009)

730 Fabric OS Command Reference
53-1001186-01
SnmpConfig
2
SnmpConfig
Manages the SNMP agent configuration.
Synopsis snmpConfig --show | --set | --default [snmpv1 | snmpv3 | accessControl | mibCapability |
systemGroup | seclevel]
Description Use this command to manage the configuration of the SNMP agent in the switch. The configuration
includes SNMPv1 and SNMPv3 configuration, access control list (ACL), MIB capability, system
group, and security level settings. The command supports set, reset to default, and display
operations.
All values successfully changed by this command take effect immediately and are persistent across
power cycles and reboots.
Note The execution of this command is subject to Virtual Fabric or Admin Domain restrictions that may
be in place. Refer to chapter 1, "Using Fabric OS commands" and Appendix A, "Command
Availability" for details.
Operands This command supports the following operands:
--show Displays the SNMP agent configuration data of the specified category.
--set Sets the SNMP agent configuration data of the specified category. This
operand displays the current settings and then prompts you to change the
values for each parameter.
--default Sets the SNMP agent configuration data for a specified item to the default
values. Generally, these default values may be available in the configuration
database. The command sets to factory defaults if the SNMP agent
configuration parameters are not available in the configuration database.
--show, --set, and --default support the following arguments:
snmpv1 Selects SNMPv1-related configuration parameters. These parameters include
the community string, trap recipient IP address, and trap severity level
associated with each trap recipient IP address.
snmpv3 Selects SNMPv3-related configuration parameters. These parameters include
the user name, authentication protocol and password, the privacy protocol
and password, the SNMPv3 trap recipient’s IP address, its associated user
index and trap severity level.
accessControl Selects access-control-related parameters. These parameters include the
access host subnet area and access permission (read-write).
mibCapability Selects configuration parameters related to the SNMP agent’s MIBs and trap
capability parameters. These parameters include MIBs and traps supported
by the SNMP agent.
systemGroup Selects configuration parameters related to the system group. These
parameters include sysDescr, sysLocation, sysContact, and authentication
failure trap.
secLevel Sets the SNMP security level.