Brocade Fabric OS Command Reference Manual v6.2.0 (53-1001186-01, April 2009)

654 Fabric OS Command Reference
53-1001186-01
portStatsShow
2
er_toolong The number of frames longer than the maximum frame length.
er_bad_eof The number of frames with bad end-of-frame.
er_enc_out The number of encoding error outside frames.
er_bad_os The number of invalid ordered sets (platform- and port-specific).
er_c3_timeout The number of class 3 frames discarded due to timeout (platform- and
port-specific).
er_c3_dest_unreach The number of class 3 frames discarded due to destination unreachable
(platform and port specific).
er_other_discard The number of other discards (platform- and port-specific).
er_zone_discard The number of class 3 frames discarded due to zone mismatch.
er_type1_miss The number of frames with FTB type 1 miss.
er_type2_miss The number of frames with FTB type 2 miss.
er_type6_miss The number of frames with FTB type 6 miss.
er_zone_miss The number of frames with hard zoning miss.
er_lun_zone_miss The number of frames with logical unit number (LUN) zoning miss.
er_crc_good_eof The number of CRC errors with good end-of-frame (EOF) (platform- and
port-specific).
er_inv_arb The number of invalid arbitrated loops (ARBs).
open The number of times the FL_Port entered OPEN state.
transfer The number of times the FL_Port entered TRANSFER state.
opened The number of times the FL_Port entered OPENED state.
starve_stop The number of loop tenancies stopped due to starvation.
fl_tenancy The number of times the FL_Port had a loop tenancy.
nl_tenancy The number of times the NL_Port had a loop tenancy.
zero_tenancy The number of times a zero tenancy occurred.
Note The execution of this command is subject to Virtual Fabric or Admin Domain restrictions that may
be in place. Refer to chapter 1, "Using Fabric OS commands" and Appendix A, "Command
Availability" for details.
Operands This command has the following operands:
slotnumber For bladed systems only, specifies the slot number of the port to be displayed,
followed by a slash (/).
[ge]portnumber Specifies the number of the port for which to display the statistics, relative to
its slot for bladed systems. Specify the optional ge option to display the GbE
port hardware statistics. Use switchShow to display a list of valid ports.
ge Displays the GbE port statistics.
ip Displays all GbE port statistics related to IP addresses that are on (not zero).