Brocade Fabric OS Command Reference Manual v6.2.0 (53-1001186-01, April 2009)

Fabric OS Command Reference 647
53-1001186-01
portShow
2
To display Byte Streaming parameters:
switch:admin> portshow fciptunnel ge1 0 -bstr
Port: ge1
-------------------------------------------
Tunnel ID 0
Remote IP Addr 192.168.32.2
Local IP Addr 192.168.32.1
Remote WWN Not Configured
Local WWN 10:00:00:05:1e:41:2f:2e
Compression off
Fastwrite on
Tape Pipelining off
Committed Rate 400000 Kbps (0.400000 Gbps)
SACK on
Min Retransmit Time 100
Keepalive Timeout 10
Max Retransmissions 8
VC QoS Mapping off
DSCP Marking (Control): 0, DSCP Marking (Data): 0
VLAN Tagging Not Configured
TCP Byte Streaming on
Status : Active
Connected Count: 9
Uptime 23 hours, 19 minutes, 45 seconds
============================================
Streaming TCP vars:
============================================
head index = 24
tail index = 24
Current Count = 0
Pending Frames High = 16
Segment Count High = 3
Data Mover Restarts = 0
Data Mover Desc Full = 0
Frame Too Large Count = 0
Max Reference Count = 15
Max Frame Size = 2116
Max Segments Pulled = 0
Reached Max Pending Frames = 0
FCIP Smoothed RTT = 202 ms
FCIP RTT Variance = 1 ms
FC control traffic TCP connection:
Local 192.168.32.1:4129, Remote 192.168.32.2:3225
Data transfer TCP connection:
Local 192.168.32.1:4130, Remote 192.168.32.2:3226
To display FICON EPCB for a GbE port 0 tunnel ID 1 with post display clearing of relevant statistics:
switch:admin> portshow ficon ge0 1 -epcb -clear
To display a list of discovered devices and selected path and status information on each. Get the
adrs from this display for the next command:
switch:admin> portshow ficon ge0 all -fdcb
To display details on the FDCB specified in the adrs argument which was derived from the previous
example:
switch:admin> portshow ficon ge0 all -fdcb 10008000