Brocade Fabric OS Command Reference Manual v6.2.0 (53-1001186-01, April 2009)

Fabric OS Command Reference 637
53-1001186-01
portShow
2
inbandmgmt Displays the status of the inband management configuration and IP
addresses configured to enable inband management on the Brocade 7500
through GbE port interfaces. This command requires a port to be specified
and displays the IP addresses for that port. In addition the output shows
whether inband management is enabled or disabled. To display the routing
table, use the portshow iproute command.
Examples To display the state of a port:
switch:admin> portshow 3/15
portName:
portHealth: HEALTHY
Authentication: None
portDisableReason: None
portCFlags: 0x1
portFlags: 0x4903 PRESENT ACTIVE E_PORT G_PORT U_PORT
SEGMENTED LOGICAL_ONLINE LOGIN LED
portType: 17.0
portState: 1 Online
portPhys: 6 In_Sync
portScn: 64 Segmented
port generation number: 12
portId: 022f00
portIfId: 4332001e
portWwn: 20:2f:00:05:1e:39:5b:75
portWwn of device(s) connected:
Distance: normal
portSpeed: N4Gbps
LE domain: 0
FC Fastwrite: OFF
Interrupts: 0 Link_failure: 9 Frjt: 0
Unknown: 0 Loss_of_sync: 4810 Fbsy: 0
Lli: 1211464 Loss_of_sig: 9617
Proc_rqrd: 95542 Protocol_err: 0
Timed_out: 0 Invalid_word: 0
Rx_flushed: 0 Invalid_crc: 0
Tx_unavail: 0 Delim_err: 0
Free_buffer: 0 Address_err: 12
Overrun: 0 Lr_in: 4
Suspended: 0 Lr_out: 7
Parity_err: 0 Ols_in: 2
2_parity_err: 0 Ols_out: 3
CMI_bus_err: 0
Port part of other ADs: No
To view xlate domains, you must be running a Brocade 7500 or a chassis with an FC4-18i blade.
Note that the Front Domain ID is what is shown:
switch:admin> portshow 8/4
portName:
portHealth: No Fabric Watch License
Authentication: None
EX_Port Mode: Enabled
Fabric ID: 20