Brocade Fabric OS Command Reference Manual v6.2.0 (53-1001186-01, April 2009)

580 Fabric OS Command Reference
53-1001186-01
portCfgShow
2
Port Auto Disable Displays On when the Auto Disable feature is enabled on a port or (..)/OFF
when disabled. This feature causes ports to become disabled when they
encounter an event that would cause them to reinitialize. This feature is
enabled by the portCfgAutoDisable command. The feature is disabled by
default.
Notes The output of this command may vary depending on the hardware platform and port type.
The execution of this command is subject to Virtual Fabric or Admin Domain restrictions that may
be in place. Refer to chapter 1, "Using Fabric OS commands" and Appendix A, "Command
Availability" for details.
Operands This command supports the following port options:
slot For bladed systems only, specifies the slot number of the port to be
configured, followed by a slash (/).
[ge]port Specifies the number of the port to be configured, relative to its slot for
bladed systems. For GigE ports, the ports are numbered ge0 - ge1. Use the
switchShow command for a list of valid ports.
Use portCfgshow with one of the following options and optional arguments to display specific
FCIP-related parameters configured for a gigabit Ethernet port:
arp Displays the address resolution protocol (ARP) table.
ipif Displays the IP interface for both ports of the tunnel. IPv6 addresses are
supported.
iproute Displays the IP route on the specified GbE port. IPv6 addresses are
supported.
mode Displays the mode of the specified GbE port. FCIP or not configured.
vlantag Displays VLAN Tagging configuration.
fciptunnel Displays FCIP tunnels on the specified GbE port. Valid arguments for
fciptunnel include.
all | tunnel_id Display includes all FCIP tunnels on the port or the specified FCIP tunnel only.
Valid values for tunnel_id are 0-7.
-ipsec Displays IKE and IPSec policy information on IPSec-enabled tunnels. This
argument is optional.
-qosmap Displays the VC to QoS mapping. This argument is optional.
inbandmgmt
Displays any inband management interfaces configured on the 7500 for a
specified GbE port.
Examples To display the port configuration settings on an enterprise-class platform:
switch:admin> portcfgshow
Ports of Slot 2 0 1 2 3 4 5 6 7 8 9 10 11 12 13 14 15
-----------------+--+--+--+--+---+--+--+--+----+--+--+--+----+--+--+--
Speed AN AN AN AN AN AN AN AN AN AN AN AN AN AN AN AN
AL_PA Offset 13 .. .. .. .. .. .. .. .. .. .. .. .. .. .. .. ..
Trunk Port ON ON ON ON ON ON ON ON ON ON ON ON ON ON ON ON
Long Distance .. .. .. .. .. .. .. .. .. .. .. .. .. .. .. ..
VC Link Init .. .. .. .. .. .. .. .. .. .. .. .. .. .. .. ..