Brocade Fabric OS Command Reference Manual v6.2.0 (53-1001186-01, April 2009)

Fabric OS Command Reference 543
53-1001186-01
portCfg
2
-P l2cos
Specifies the L2 Class Of Service (COS) Tagging value. Use the portShow
fciptunnel geport all -qosmap command to display current values.
Supported range is 0-7.
ipif Defines the IP interface for both ports of a tunnel. Up to eight IP interfaces
per GbE port are supported. The IP network connection between two 7500
routers or two FC4-18i blades is configured by defining IP interfaces for origin
and destination virtual ports, and then defining one or more IP routes to
connect them. IPv6 addresses are supported on switches running v6.0 or
later. The syntax for portCfg ipif is as follows:
portcfg ipif [slot/][ge]port option arguments
Valid options and arguments for ipif are:
create src_ipaddr mtu_size
Creates IP interfaces. Specify the following:
src_ipaddr Specifies source IP address in either IPv6 or IPv4 format:
src_IPv6_addr/prefix_len
Specifies the source IPv6 address of the virtual port if IPv6 is used. The
address must be an IPv6 global, unicast address, followed by a prefix.
This is used for IPv6 addresses instead of a netmask. The prefix_len
operator is required.
src_IPv4_addr netmask
Specifies the source IPv4 address of the virtual port, if IPv4 is used. If an
IPv4 address is used, the subnet mask must be specified as well (in
a.b.c.d. format.)
mtu_size Specifies the maximum transmission unit size. The range allowed is
1260 to 2348 KB. This operand is required.
delete ipaddr Deletes IP interfaces. Specify the IPv6 or IPv4 address of the virtual port.
iproute Defines static IP routes on a GbE port. After defining the IP interface of the
remote switch, you can define destination routes for an interface. A maximum
of 40 routes per GbE port are supported. IPv6 addresses are supported on
platforms running v6.0.0 or later. You cannot use this command to configure
routes for inband management; use portCfg inbandmgmt instead.
The syntax for portcfg iproute is as follows:
portcfg iproute [slot/][ge]port option arguments
Valid options and arguments for iproute are:
create dest_ipaddr [gateway_router] metric
Creates IP routes, where:
dest_ipaddr Specifies the destination IP address in either IPv6 or IPv4 format: