Brocade Fabric OS Command Reference Manual v6.2.0 (53-1001186-01, April 2009)

134 Fabric OS Command Reference
53-1001186-01
cryptoCfg
2
- Type: tape or disk
- EE node: node WWN
- EE slot: slot number
- Target: target port WWN, node WWN
- VT: virtual target port WWN, node WWN
- Number of hosts
- Configuration status: committed or defined
- For each host: host port WWN, node WWN
- For each VI: VI port WWN, node WWN
- Number of LUNs
If a re-key session is in progress while the command is run, the following additional information is
displayed:
• LUN number
• LUN type: tape or disk
• LUN serial number
• Encryption mode: encrypt or cleartext
• Encryption format: native or DF compatible
• Encrypt existing data: enabled or disabled
• Rekey: enabled or disabled
• LUN state: See the appendix in the Admin Guide.
• Encryption algorithm
• Key ID state: Re-key
• Key ID
• Key creation time
• Key life (in days)
• Rekey status
• Key expiration time
• Rekey session number
• Percentage complete
• Rekey state: Read or write Phase
• Rekey role: primary, alternate
• Block size
• Number of block
• Current logical block address (LBA) being processed
Use the --show -tapepool command to display tape pool configuration parameters for all Tape
pools or for a specific tape pool. For each tape pool, the display includes the following information:
• tape pool Label
• Key Life: Life span in minutes
• Encryption mode: encrypt or cleartext
• Encryption format: native or DF compatible