Brocade Fabric OS Command Reference Manual v6.2.0 (53-1001186-01, April 2009)

126 Fabric OS Command Reference
53-1001186-01
cryptoCfg
2
--set -hbmisses Sets the number of heartbeat misses allowed in a node that is part of an
encryption group before the node is declared unreachable. This value is set in
conjunction with the time-out value. It must be configured at the group leader
node and is distributed to all member nodes in the encryption group. The
following operand is required:
value Specifies the number of heartbeat misses. The default value is 3. The range
is 1-15 in integer increments only.
--set -hbtimeout Sets the time-out value for the heartbeat. This parameter must be configured
at the group leader node and is distributed to all member nodes in the
encryption group. The following operand is required:
value Specifies the heartbeat time-out in seconds. The default value is 2 seconds.
Valid values are integers in the range between 1 and 30 seconds.
--add -membernode
Adds the specified member node to the existing encryption group. The
member node is specified by its node WWN. This command is valid only on
the group leader. Initial setup on the node must be performed prior to adding
the node to an encryption group.
This command is required only when a node that was earlier part of
encryption group (online and DISCOVERED) was ejected or left the encryption
group and is now added back to that encryption group. A member node that
is online during registration is added automatically to the encryption group.
The following operand is required:
node_WWN Specifies the WWN of the node to be added back to the encryption group.
--eject -membernode
Removes a member node from the existing encryption group. The node is
specified by its node WWN. This command is valid only on the group leader.
The node must be online (in DISCOVERED state) for this command to
succeed. To remove a node that is not online (in DISCOVERING State), use
--dereg -membernode. You must remove the EEs from the HA cluster and
delete any Crypto Target container/LUN configurations from this node before
ejecting the node or the command fails. The following operand is required
when ejecting a member node:
node_WWN Specifies the node WWN of the node to be removed from the encryption
group.
--leave_encryption_group
Clears the node's states pertaining to the node's membership in the
encryption group. This command is invoked from the member node that is to
be ejected from the encryption group.The node must be online (in
DISCOVERED state) for this command to succeed. To remove a node that is