Brocade Fabric OS Command Reference Manual v6.2.0 (53-1001186-01, April 2009)

114 Fabric OS Command Reference

53-1001186-01

configureChassis

System Settings

The following system-related parameters are configurable on a Virtual Fabric-aware switch.

TABLE 11 System settings

system.blade.bladeFaultOnHwErrMsk

If this field is set to a value other than 0, then any nonfatal HW ASIC data

parity error causes the problem blade to be powered off.

Examples To enable signature validation for downloading firmware:

switch:admin> configurechassis

Configure...

cfgload attributes (yes, y, no, n): [no] y

Enforce secure config Upload/Download (yes, y, no, n): [no]

Enforce signature validation for firmware (yes, y, no, n): [no]yes

System (yes, y, no, n): [no]

See Also configDefault, configShow, chassisEnable, chassisDisable, configure, ipAddrSet,

portCfgLongDistance, switchDisable, switchEnable, upTime

Field Type Default Range

system.blade.bladeFaultOn

HwErrMsk

Number

0x0 0x0 to 0xffff