Manualshelf

Brocade Fabric OS Command Reference Manual Supporting Fabric OS v6.4.0 (53-1001764-01, March 2010)

ManualsBrandsHP ManualsStorageBrocade 8/24c SAN Switch for BladeSystem c-Class
661662663664665666667668669670
Fabric OS Command Reference 635
53-1001764-01
portCfg
2
To create an FCIP tunnel using IPV6:
switch:admin> portcfg fciptunnel 8/ge0 create 0 4000::1234 2000::800:3333:1234 0
Operation Succeeded
To modify the committed rate and turn on compression on an existing FCIP tunnel:
switch:admin> portcfg fciptunnel 3/ge0 modify 6 -b 100000 -c 1
Operation Succeeded
To create an FCIP tunnel with VC QoS mapping (default) turned on:
switch:admin> portcfg fciptunnel ge1 create 1 192.168.200.109 192.168.200.108 0 -M
To modify the default VC QoS map settings for VC 1:
switch:admin> portcfg fciptunnel ge1 qosmap 1 3 -Q 29
switch:admin> portcfg fciptunnel ge1 qosmap 1 3 -Q 28 -P 7
switch:admin> portcfg fciptunnel ge1 qosmap 1 3 -P 2
To return the VC QoS map settings to default values:
switch:admin> portcfg fciptunnel ge1 qosmap 1 -default
To create an FCIP tunnel with a minimum retransmission time of 20 ms, a VLAN ID of 100, and an
L2 CoS priority setting of 7:
switch:admin> portcfg fciptunnel 8/ge0 create 1 192.168.10.1 192.168.20.1 0 -m 20 -v 100 -p 3 -P 7
Operation Succeeded
To create an FCIP tunnel with FastWrite and read/write Tape Pipelining enabled:
switch:admin> portcfg fciptunnel 3/ge0 create 6 10.1.1.44 192.168.131.124 155000 -f -t
To enable FCIP FastWrite and read/write Tape Pipelining on an existing tunnel:
switch:admin> portcfg fciptunnel ge1 modify 0 -f 1
To create an FCIP tunnel with Byte Streaming enabled:
switch:admin> porrtcfg fciptunnel geo create 1 172.68.100.88 192.168.200.108 0 -f1 -bstr
To disable Byte Streaming on an existing tunnel:
switch:admin> portcfg fciptunnel ge0 modify 1-bstr 0
To configure an FCIP Tunnel 1 with FICON XRC and FICON write Tape Pipelining emulation features
enabled using all default parameter arguments:
switch:admin> portcfg ficon ge0 1 -x 1 -w 1
Function Commands supported only on the Brocade 7500/7500E switches
Synopsis portcfg inbandmgmt ge_port option arguments
Description Use this command to configure IP addresses and routes for the CP or GbE port inband
management interfaces on the Brocade 7500. Inband management allows a management station
to communicate with the CP through GbE ports.