Brocade Fabric OS Command Reference Manual Supporting Fabric OS v6.3.0 (53-1001337-01, July 2009)

744 Fabric OS Command Reference
53-1001337-01
portThConfig
2
UTIL Port utilization
PKTLOSS Packet loss
ST State change
optional_arguments
The following operands are optional and valid only with the --show option.
They work as filters to display partial views
-current_status Displays current values for a specified port type and area, as registered
by Fabric Watch, or for all port types and areas. The output includes
PortType, Area, Port number, Circuit ID (for the Brocade 7800 and FS8-24
only), Value, and State. The State field reports whether the current value
is above, in range, or below (info) the configured threshold.
-thresh_level default | custom
Displays default or custom threshold configuration settings.
-action_level default | custom
Displays default or custom configuration settings.
.
The following operands are optional and valid only with the --set option.
Defaults for these parameters vary depending on the area and platform.
Refer to the Fabric Watch Administrator’s Guide for specific details.
-timebase time_base
Specifies the time interval between two samples to be compared. Valid
values for time_base are:
day Samples are compared once a day.
hour Samples are compared once every hour.
minute Samples are compared once every minute.
second Samples are compared once every second.
-highthreshold -value value
Specifies the high threshold value for triggering a specified alert action.
To change the default value, provide an integer value.
-lowthreshold -value value
Specifies the low threshold for triggering a specified alert action. To
change the default value, provide an integer value.
-trigger above | below
Specifies the actions for in range port behavior. In range is defined as the
space above the low threshold and below the high threshold.
-action Specifies the actions triggered by a configured event condition. Valid
values include one or more of the following actions. If more than one
action is specified, the actions must be separated commas.
raslog Event triggers a RASlog message.
snmp Event triggers an SNMP trap.
email Event triggers an e-mail.
poortlog Event triggers a port log entry