Brocade Fabric OS Command Reference Manual Supporting Fabric OS v6.3.0 (53-1001337-01, July 2009)

xxiv Fabric OS Command Reference
53-1001337-01
• cfgUpload, cfgDownload - New -vf option to upload Virtual Fabric configuration parameters.
(RAS)
• configure - XISL use enabled by default (Logical Fabrics)
• cryptoCfg
- New operands to support system cards, quorum size, and the Thales nCipher key vault.
• –-set -systemcard enable | disable
• –-reg –KAClogin primary | secondary
• --show –egstatus -cfg|-stat.
• –-sync –encgroup
• –-set -quorumseize
• cfgAdd, cfgCreate, cfgRemove, cfgDelete, cfgEnable - Modified to remove reference to port
area.
• fosConfig - New –-ethsw operand to enable the Ethernet Switch service (for
upgrade/downgrade).
• fosExec - New –-fid all option to execute a command on all logical switches.
• help - New-page operand to display help command one page at a time.
• interopMode
- New operands to configure domain ID offset.
• –-enable mode -domainoffset
• –-disable mode -domainoffset
• lfCfg - Expanded display to include all logical switches.
• licenseShow - Output modification to support new licensing requirements (upgrade licensing,
slot-based licensing).
• portCfg
- New operands for adding and deleting circuits to a tunnel (FCIP, Brocade 7800/FX8-24
platforms).
- Modification to fciptunnel (FCIP Adaptive Rate Limiting, Brocade 7800/FX8-24 platform).
- portCfgShow - Support for Brocade 7800/FX8-24 platforms.
• portCmnd - New -tperf option.
• portPerfShow - New TX/TR bandwidth display options.
• portshow - Support for Brocade 7800/FX8-24 platforms.
- New operands to support the Brocade 7800/fX8-24 platforms.
- Output modification to support QoS over FCR.
- Output modification to show 1/10 GbE Port and other FCIP related information (FCIP -
distance products).
• zone commands
- Modification to remove references to port area.
- Added support for creating and maintaining QoS zones with D,I format (QoS D,I zones).
• secCertUtil - New -nowarn option to block import of invalid SSL certificates.
• snmpConfig - New option in –-set snmpv3 to enable or disable informs (interactive).