Brocade Fabric OS Command Reference Manual Supporting Fabric OS v6.3.0 (53-1001337-01, July 2009)

130 Fabric OS Command Reference

53-1001337-01

configureChassis

Custom Attributes

Table 11 lists custom attributes that may be modified.

config Index OEM custom configuration. This attribute is for internal use only.

System Settings

The following system-related parameters are configurable on a Virtual Fabric-aware switch.

TABLE 12 System settings

system.blade.bladeFaultOnHwErrMsk

If this field is set to a value other than 0, then any nonfatal HW ASIC data

parity error causes the problem blade to be powered off.

Examples To enable signature validation for downloading firmware:

switch:admin> configurechassis

Not all options will be available on an enabled switch.

To disable the switch, use the "switchDisable" command.

Configure...

cfgload attributes (yes, y, no, n): [no] y

Enforce secure config Upload/Download (yes, y, no, n): [no]

Enforce signature validation for firmware (yes, y, no, n): [no]yes

Custom attributes (yes, y, no, n): [no]

System (yes, y, no, n): [no]

See Also configDefault, configShow, chassisEnable, chassisDisable, configure, ipAddrSet,

portCfgLongDistance, switchDisable, switchEnable, upTime

TABLE 11 Configurable custom attributes

Application Attribute Type Default Range

Custom Config Index (0 to ignore): Number 0 0-10000

Field Type Default Range

system.blade.bladeFaultOn

HwErrMsk

Number

0x0 0x0 to 0xffff