Brocade Fabric OS Administrator's Guide Supporting Fabric OS v6.3.0 (53-1001336-02, November 2009)

290 Fabric OS Administrator’s Guide
53-1001336-02
iSNS client service configuration
12
Enter the isnsccfg --set command with the -m and -s options to set the IP address of the iSNS
server management port rather than the GbE port:
switch:admin> isnsccfg --set -m -s IP_address
where IP_address is the iSNS server management port IP address.
The following is an example.
switch:admin> isnsccfg –set –m –s 10.33.56.105
iSNS client configuration updated: peering with iSNS server 10.33.56.105 on
the management port.
5. Enter the isnscCfg --show command to verify that the iSNS server has been configured
correctly:
switch:admin> isnsccfg --show
iSNS client is peering with iSNS server 10.33.56.105 on the management port.
Operational Status: Connected to iSNS server.
6. Enter the isnsccfg --reregister command to re-register the iSNS objects:
switch:admin> isnsccfg --reregister
Disabling the iSNS client service
When the iSNS client service is disabled, the DD and DDSets are kept in the fabric.
1. Connect and log in to the switch.
2. Enter the fosConfig
--disable isnsc command to disable the iSNS client service:
switch:admin> fosconfig --disable isnsc
3. Enter the fosConfig --show command to verify that the service is disabled:
switch:admin> fosconfig --show
FC Routing service:disabled
iSCSI service:enabled
iSNS Client service:disabled
Clearing the iSNS client configuration
The iSNS client configuration can be cleared with a single command.
1. Connect and log in to the switch.
2. Enter the isnscCfg
--clear command to clear the iSNS configuration:
switch:admin> isnsccfg --clear
Cleared iSNS server IP address