Brocade Fabric OS Administrator's Guide Supporting Fabric OS v6.3.0 (53-1001336-02, November 2009)

268 Fabric OS Administrator’s Guide
53-1001336-02
FC4-16IP blade configuration
12
iSCSI service is enabled
4. Verify that the iSCSI gateway service is enabled.
switch:admin> fosconfig --show
FC Routing service:disabled
iSCSI service:enabled
iSNS Client service:disabled
Enabling GbE ports
By default, GbE ports are enabled on an FC4-16IP blade installed in the Brocade 48000. However,
if you insert the FC4-16IP blade into a slot that was previously occupied by an FR-18i blade, GbE
ports are disabled.
Before enabling the physical iSCSI interface, enable the iSCSI gateway service as described in
“Enabling the iSCSI gateway service” on page 267.
NOTE
The GbE port number port_number below is entered geX; where X is from 0 through 7.
For example ge1 (see Figure 36 on page 267).
1. Connect and log in to the switch.
2. Enter the portCfgShow command with the blade slot number and GbE port number parameters
to display the Persistent Disable setting of the port.
switch:admin> portcfgshow 10/ge0
Mode: ISCSI
Persistent Disable: ON
Ipif configuration:
Interface IP Address NetMask MTU
----------------------------------------------------------
0 30.0.130.100 255.255.0.0 1500
Arp configuration:
IP Address Mac Address
------------------------------
Iproute Configuration:
IP Address Mask Gateway Metric
------------------------------------------------------
3. Take the appropriate action based on the Persistent Disable setting:
- If it is set to OFF, proceed to step 4.
- If it is set to ON, enter the portCfgPersistentEnable command with the slot number and
GbE port number.
switch:admin> portcfgpersistentenable 10/ge0
4. Enter the portCfgShow command with the slot number and GbE port number to verify that the
port is persistently enabled.
In the following sample output, the Persistent Disable setting is set to OFF.