Brocade Access Gateway Administrator's Guide v6.2.0 (53-1001189-01, April 2009)

58 Access Gateway Administrator’s Guide
53-1001189-01
Troubleshooting
A
NOTE
If a Fabric OS switch is in Access Gateway mode and is also set to McDATA Fabric mode, when that
switch is connected to an M-EOS switch, the Fabric OS switch does not display in the output when
you run the agshow command.
Failover is not working Failover disabled on N_Port. Verify that failover and failback policies are enabled, as follows:
Enter the ag
--failoverShow command with the <port_number>
operand.
Enter the ag
--failbackShow command with the <port_number>
operand.
Command returns “Failback (or Failover) on N_Port <port_number> is
supported.”
If it returns, “Failback (or Failover) on N_Port <port_number> is not
supported.” See “Adding a preferred secondary N_Port” on page 52.
Access Gateway is mode
not wanted
Access Gateway must be disabled. Disable switch using the switchDisable command.
Disable Access Gateway mode using
the ag
--modeDisable command.
Answer yes when prompted; the switch reboots.
Log in to the switch.
Display the switch settings using the switchShow command. Verify
that the field switchMode displays Fabric OS native mode.
TABLE 12 Troubleshooting (Continued)
Problem Cause Solution