Brocade Access Gateway Administrator's Guide v6.2.0 (53-1001189-01, April 2009)

xiv Access Gateway Administrator’s Guide
53-1001189-01
What’s new in this document
The following changes have been made since this document was last released:
Information that was added:
• Supported software
• M-EOSc products: Release 9.1 or later and 9.6 or later
• Cisco Products: SAN-OS 3.0(1) or later and 3.1(1) or later
• Supported platforms
• Brocade 300 (24-port version only), 5100
• Embedded switches: 5410, 5424, 5480
• Supported configurations in cascaded AG
For further information, refer to the release notes.
Document conventions
This section describes text formatting conventions and important notices formats.
Text formatting
The narrative-text formatting conventions that are used in this document are as follows:
bold text Identifies command names
Identifies the names of user-manipulated GUI elements
Identifies keywords and operands
Identifies text to enter at the GUI or CLI
italic text Provides emphasis
Identifies variables
Identifies paths and Internet addresses
Identifies document titles
code text Identifies CLI output
Identifies syntax examples
For readability, command names in the narrative portions of this guide are presented in mixed
lettercase: for example, switchShow. In actual examples, command lettercase is often all
lowercase. Otherwise, this manual specifically notes those cases in which a command is case
sensitive. The ficonCupSet and ficonCupShow commands are an exception to this convention.
Command syntax conventions
Command syntax in this manual follows these conventions: