Brocade 8Gb SAN Switch for HP BladeSystem c-Class user guide (5697-0960, May 2011)
Table Of Contents
- Brocade 8Gb SAN Switch for HP BladeSystem c-Class
- Contents
- About this guide
- 1 Overview
- 2 Setup
- Shipping carton contents
- Installation and safety considerations
- Install the 8Gb SAN Switch
- Set the switch Ethernet IP address
- Configure the 8Gb SAN Switch
- Items required for configuration
- Connect to the Command Line Interface
- Setting the date and time
- Verifying installed licenses
- Modifying the FC domain ID (optional)
- Disabling and enabling a switch
- Disabling and enabling a port
- Using Dynamic Ports On Demand (DPOD)
- DPOD commands
- Verifying the configuration
- Backing up the configuration
- 3 Managing the 8Gb SAN Switch
- A Regulatory compliance and safety
- B Electrostatic discharge
- C SAN Switch technical specifications
- Glossary
- Index
FCS switch Fabric Configuration Server switch. One or more designated HP switches that
store and manage the configuration and security parameters for all switches in
the fabric.
Fibre Channel The primary protocol for building SANs to transmit data between servers,
switches, and storage devices. Unlike IP and Ethernet, Fibre Channel is designed
to support the needs of storage devices of all types. It is a high-speed, serial,
bidirectional, topology-independent protocol, and is a highly scalable
interconnection between computers, peripherals, and networks.
fill word An IDLE or ARB ordered set that is transmitted during breaks between data frames
to keep the link active.
FLOGI The process by which an N_Port determines whether a fabric is present and, if
so, exchanges service parameters with it. See also PLOGI.
FL_Port Fabric loop port. A port that is able to transmit under fabric protocol and has
arbitrated loop capabilities. Can also be used to connect an NL_Port to a switch.
See also U_Port.
frame The Fibre Channel structure used to transmit data between ports. Consists of a
start-of-frame delimiter, header, optional headers, data payload, cyclic
redundancy check, and end-of-frame delimiter. There are two types of frames:
link control frames and data frames. See also packet.
FRU Field-replaceable unit. A component that can be replaced on site.
FS Fibre Channel Service. A service that is defined by FC standards and exists at
a well-known address. The Simple Name Server, for example, is an FC service.
FSP Fibre Channel Service Protocol. The common protocol for all fabric services; it
is transparent to the fabric type or topology.
FSPF Fabric shortest path first. HP routing protocol for FC switches.
Fx_Port A fabric port that can operate as an F_Port or FL_Port.
G_Port Generic port. A port that can operate as an E_Port or F_Port. A port is defined
as a G_Port when it is not yet connected or has not yet assumed a specific
function in the fabric. See also E_port, F_port, U_Port.
hard address The AL_PA that an NL_Port attempts to acquire during loop initialization. See
also defined zone configuration.
idle Continuous transmission of an ordered set over an FC link when no data is being
transmitted, to keep the link active and maintain bit, byte, and word
synchronization.
integrated fabric The fabric created by connecting multiple HP switches with multiple ISL cables,
and configuring the switches to handle traffic as a seamless group.
ISL trunking The distribution of traffic over the combined bandwidth of multiple ISLs. A set of
trunked ISLs is called a trunking group; the ports in a trunking group are called
trunking ports.
isolated E_Port An E_Port that is online but not operational due to overlapping domain IDs or
nonidentical parameters (such as E_D_TOVs). See also E_D_TOV.
Brocade 8Gb SAN Switch for HP BladeSystem c-Class 57