Reference Guide

Distributed Deployment
The BIMS ACS modules may be installed on more than one server to meet specific performance
requirements. A typical scenario is where the system has one Master server with BIMS Platform
deployed and multiple Slave servers with BIMS ACS modules deployed.
To install the BIMS on a Slave Server, perform the following steps:
1. Select Start/All Programs/HP Intelligent Management Center/HP Deployment
Monitoring Agent.
2. In the window displayed, select Stop IMC in the Monitor tab to stop all processes of
IMC.
3. In the Deploy tab, right-click the BIMS ACS component, select Deploy the Component
from the shortcut menu.
4. A dialog box appears, indicating that the component was successfully deployed. Click
OK.
[ Table of Contents ]
TCP Port Usage
The BIMS Server will BIND to and use the following TCP/IP Ports.
Port
Usage
TCP 8025
Used to receive SHUTDOWN command for the jserver process.
TCP 9091
The JMX monitoring port used by the jserver process.
TCP 9044
Used to receive SHUTDOWN command to the HP IMC Server service process.
TCP 9055
Used to receive SHUTDOWN command to the Deployment Monitoring Agent
process.
TCP 61616
Used for communication in a Master-Slave deployment environment.
TCP 61626
Used for communication to the HP IMC Server and Deployment Monitoring
Agent.
UDP 161
Used to access network elements through SNMP.
UDP 162
Used to accept SNMP Traps from network elements.
TCP 22
SSH/SFTP port, which the configuration center uses to back up and restore the
device software and configuration file through SSH/SFTP.
TCP 20/21
FTP port, which the configuration center uses to back up and restore the device
software and configuration file through FTP.