Specifications
Table Of Contents
- HP ProLiant BL460c Generation 5 Server Blade Maintenance and Service Guide
- Notice
- Contents
- Customer self repair
- Illustrated parts catalog
- Removal and replacement procedures
- Required tools
- Safety considerations
- Server blade preparation
- Access panel
- Hard drive blank
- Hard drive
- FBDIMM
- Hard drive backplane
- Hard drive backplane retainer
- Front panel/hard drive cage assembly
- Mezzanine card
- HP Smart Array E200i Controller cache module
- HP Smart Array E200i Controller battery pack
- Server blade handle
- Release button
- Heatsink
- Processor
- System board
- System battery
- Diagnostic tools
- Component identification
- Specifications
- Acronyms and abbreviations
- Index
Removal and replacement procedures 47
5.
Close the processor retaining latch and the processor socket retaining bracket.
6. Clean the old thermal grease from the heatsink and the top of the processor with the alcohol swab.
Allow the alcohol to evaporate before continuing.
7. Apply all the grease to the top of the processor in one of the following patterns to ensure even
distribution:
8. Install the heatsink ("Heatsink" on page 36).
IMPORTANT: Install all components with the same configuration that was used on the failed
system board.
9. Install all components removed from the failed system board.
10. Install the hard drives ("Hard drive" on page 25).
11. Install the hard drive blanks ("Hard drive blank" on page 25).
12. Install the access panel ("Access panel" on page 24).
13. Power up the server blade.