Specifications

Removal and replacement procedures 38
3.
Install the heatsink.
4. Install the front panel/hard drive cage assembly ("Front panel/hard drive cage assembly" on page
30).
5. Install the hard drive backplane ("Hard drive backplane" on page 28).
6. Install the hard drives ("Hard drive" on page 25).
7. Install the hard drive blanks ("Hard drive blank" on page 25).
8. Install the access panel ("Access panel" on page 24).
9. Install the server blade.
Processor
WARNING: To reduce the risk of personal injury from hot surfaces, allow the drives and the
internal system components to cool before touching them.
CAUTION: To prevent possible server malfunction, do not mix processors of different speeds or
cache sizes. Refer to the label on the processor heatsink for a description of the processor.
CAUTION: To prevent possible server blade overheating, always populate processor socket 2
with a processor and a heatsink or a processor socket cover and a heatsink blank.
IMPORTANT: Processor socket 1 must always be populated. If processor socket 1 is empty, the
server blade does not power up.
To remove the component:
1. Power down the server blade (on page 23).
2. Remove the server blade (on page 23).
3. Remove the access panel ("Access panel" on page 24).
4. Remove all hard drives ("Hard drive" on page 25).
5. Remove all hard drive blanks ("Hard drive blank" on page 25).