Specifications
Table Of Contents
- HP ProLiant BL460c Generation 5 Server Blade Maintenance and Service Guide
- Notice
- Contents
- Customer self repair
- Illustrated parts catalog
- Removal and replacement procedures
- Required tools
- Safety considerations
- Server blade preparation
- Access panel
- Hard drive blank
- Hard drive
- FBDIMM
- Hard drive backplane
- Hard drive backplane retainer
- Front panel/hard drive cage assembly
- Mezzanine card
- HP Smart Array E200i Controller cache module
- HP Smart Array E200i Controller battery pack
- Server blade handle
- Release button
- Heatsink
- Processor
- System board
- System battery
- Diagnostic tools
- Component identification
- Specifications
- Acronyms and abbreviations
- Index
Removal and replacement procedures 29
To replace the component:
1. Install the hard drive backplane. Press down on the hard drive backplane retainer to seat the board.
2. Install the hard drives ("Hard drive" on page 25).
3. Install the hard drive blanks ("Hard drive blank" on page 25).
4. Install the access panel ("Access panel" on page 24).
5. Install the server blade.
Hard drive backplane retainer
To remove the component:
1. Power down the server blade (on page 23).
2. Remove the server blade (on page 23).
3. Remove the access panel ("Access panel" on page 24).
4. Remove all hard drives ("Hard drive" on page 25).
5. Remove all hard drive blanks ("Hard drive blank" on page 25).
CAUTION: Remove all hard drives and hard drive blanks before removing the hard drive
backplane.
6. Remove the hard drive backplane ("Hard drive backplane" on page 28).