Specifications

Removal and replacement procedures 37
5.
Remove the mezzanine card.
CAUTION: To prevent damage to the server blade, apply pressure over the mezzanine
connector when installing the mezzanine card. Do not apply pressure to the edges of the card.
To replace the component, reverse the removal procedure.
Server A system board
To remove the component:
1. Power down the server blade (on page 23).
2. Remove the server blade (on page 23).
3. Access the internal server components (on page 24).
4. Remove the server A USB key, if installed.
5. If installed, remove one of the following:
o Hard drive (on page 25)
o Cache module battery (on page 34)
6. Remove all DIMMs ("DIMMs" on page 27).
7. Remove any mezzanine cards ("Mezzanine card" on page 36).
8. Remove the heatsink ("Heatsink" on page 27).
9. Remove the cache module battery cable, if installed.