User's Manual

HP Designjet T Series — Service Manual 2-7

System Error Codes - Full Descriptions

This sections describes each of the system error codes and warnings that

could be encountered while using the printer and provides the remedial

action required to solve the problem detected.

Only replace one component at a time and check if the

error has gone before replacing another component. Using

this procedure you will be able to determine exactly which

component failed.

System Error: 01.0:YZ

Problem

Description:

Communication with Main PCA failed.

Corrective Action: Try the following:

1 Switch the Power OFF from the back of the Printer and disconnect the Power

cord

. Reconnect the power cord and power On the Printer.

2 Remove the formatter and reinsert it again. Ensure that it connects properly

in the

Main PCA connector.

 If the System Error continues, replace the Main PCA. See Electronics

Module Main PCA and PSU (T1100/T1100ps/T610) on page 6-202 or

Electronics Module Main PCA and PSU (T1120/T1120ps) on page 6-

205.

 If the System Error continues, replace the Formatter. See Formatter on

page 6-200.

10 Replace

hp qualified

personne

assistance

required

11 Reseat/Reconnect/Clean/Adjust (manually)

12 Calibrate/Adjust (using Automatic Process)

13 Power OFF

14 Upgrade System Firmware

15 Upgrade Driver or Computer Software

16 Add Accessory

17 Escalate

18 Send Plot Again

Wrong Part Installed

Code Recovery Action Response