User's Manual

HP Designjet T Series — Service Manual 6-239
Removal and Installation - Right Starwheel Lifter (T1100/T1100ps/T610)
Right Starwheel Lifter (T1100/T1100ps/T610)
Removal
1. Remove the Front Cover on page 6-16.
2. Remove the
Right Cover on page 6-27.
3. Remove the
Starwheel Assembly on page
6-208.
4. Loosen the T-10 uncapping screw
sufficiently so you can manually move the
Carriage Assembly in step 5.
If you are uncapping a 44 inch
printer, you will need to use either
a very long or very short
screwdriver to loosen the
uncapping screw. In this way, you
can loosen the screw and pass the
rewinder motor.
5. Push the Carriage Assembly into the print
path.
Switch off the printer and remove the power cable.
44 inch T1100 printer shown (with Rewinder)