User's Manual

HP Designjet T Series — Service Manual 6-205

Removal and Installation - Electronics Module Main PCA and PSU (T1120/T1120ps)

Electronics Module Main PCA and PSU (T1120/T1120ps)

Removal

1. Remove the Left Cover on page 6-30.

2. Disconnect all the connectors on the

Electronics Module. The ferrite on the left

will be located under the board, so take

care.

The two parallel connectors,

white (A) and black (B), on the

right of the board, cannot be

connected backwards or

swapped.

The harness cable (A) connects to

the white connector. The flat

cable (B)connects to the black

connector.

3. Unroute all the cables disconnected in the

previous step.

4. Remove two T-15 screws that secure the

Electronics Module to the Printer.

Switch off the printer and remove the power cable.