User's Manual

HP Designjet T Series — Service Manual 6-141
Removal and Installation - Belt Assembly
Belt Assembly
Removal
1. Remove the Carriage Assembly. See page
6-116 or 6-127 depending on the printer
model.
2. Slide the Belt Assembly out of the
attachment on the Carriage Assembly.
3. Remove the pulley to release the Belt
Assembly from the Belt Tensioner.
When you finish installing or replacing this component, you must perform the
necessary Service Calibrations. To find which calibrations you must perform,
see Service Calibration Guide to Removal and Installation
on page 6-5.
Switch off the printer and remove the power cable.