User's Manual

6-136 HP Designjet T Series — Service Manual
Removal and Installation
36.Remove the Scan Side Panel.
37. Carefully slide the Carriage Assembly and
Belt Assembly out of the printer (and the
Trailing Cable if you are removing it with
the Carriage Assembly).
38.Remove the cutter assembly.
When you reinstall the Carriage Assembly, take care not to damage the PRS
Slider.
When you finish installing or replacing this component, you must perform the
necessary Service Calibrations. To find which calibrations you must perform,
see Service Calibration Guide to Removal and Installation
on page 6-5.