User's Manual

6-100 HP Designjet T Series — Service Manual
Removal and Installation
6. Loosen the T-10 uncapping screw
sufficiently so you can manually move the
Carriage Assembly in step
7.
7. Push the Carriage Assembly into the print
path.
8. Unclip the Encoder Strip tensioner from the
right hand end and remove the encoder
strip straight out.
When you finish installing or replacing this component, you must perform the
necessary Service Calibrations. To find which calibrations you must perform,
see Service Calibration Guide to Removal and Installation
on page 6-5.
1
2
3