User's Manual

6-94 HP Designjet T Series — Service Manual
Removal and Installation
Left Roll Guide
Removal
1. Remove the Spindle on page 6-79.
2. Remove the
Clean Out Assembly on page
6-90.
3. Remove five T-15 screws that secure Left
Roll Guide to the printer.
4. Lower the left end and remove the Left Roll
Guide from the printer.
When you finish installing or replacing this component, you must perform the
necessary Service Calibrations. To find which calibrations you must perform,
see Service Calibration Guide to Removal and Installation
on page 6-5.
Switch off the printer and remove the power cable.