User's Manual

6-8 HP Designjet T Series — Service Manual
Removal and Installation
Performing the Service Calibrations and Diagnostic Tests
When you are ready to perform the service calibrations and diagnostic tests that correspond to the
component you have installed or replaced, consult the following page numbers for procedures:
 PRS Test on page 3-9
 Scan Axis Test on page 3-11
 Cutter test on page 3-16
 Star Wheel Lifter test on page 3-7
 2. Paper Drive on page 3-18
 3. Electronics Module on page 3-21
 4. Carriage Assembly on page 3-26
 5. Sensors on page 3-31
Preventive Maintenance
Kit #1
2 1 4 3 5
Preventive Maintenance
Kit
#2
1 2 3
Preventive Maintenance
Kit
#3
1 2
Cutter Assembly 1
Right Spindle Holder
(re
winder included)
1 2
Top Cover 1
Ink Supply Tubes
Su
pport Rail
1 2
PRS Test Scan Axis Test Cutter test Star Wheel Lifter test 2. Paper Drive 3. Electronics Module 4. Carriage Assembly 5. Sensors 6. Rewinder 7. Ink Delivery System (IDS) 8. Service Station Paper Advance Calibration Drop Detector Calibration Line Sensor Calibration Reset Life Counters (after replaement ONLY)