User's Manual

Service Calibrations
4-10 HP Designjet T Series — Service Manual
17 The Printer prompts you to remove the media.
18 The Printer prompts you to lower the media lever.
If the Paper Advance Calibration fails for any reason, a warning message
will appear on the Front Panel. In this case, try the following:
 Retry the Paper Advance Calibration.
 If necessary, perform a Printhead Recovery through the Front Panel and
retry the calibration.
Remove the pattern from the printer and leave it to dry for
a few minutes before continuing with the Calibration.
MAKE SURE NO MEDIA IS LOADED INTO THE PRINTER
BEFORE STARTING TO SCAN THE CALIBRATION PATTERN.
19 You will need to re-enter the Paper Advance Calibration submenu and scroll
to Scan Calibration Pattern and press OK.
20 When the following message appears on the front panel, you must select
whether you would like to continue with the calibration by pressing the OK
key. Press Back or Cancel to exit the calibration.
21 A message will appear advising you that you will need to load the
Calibration Pattern in to the Printer. Make sure that you rotate the printed