User's Manual
b. Open a Web browser, and in the address line, type the IP address or host name exactly as it
displays on the product control panel. Press the Enter key on the computer keyboard. The EWS
opens.
NOTE: If the Web browser displays a There is a problem with this website’s security certicate
message when attempting to open the EWS, click Continue to this website (not recommended).
Choosing Continue to this website (not recommended) will not harm the computer while
navigating within the EWS for the HP product.
2. Open the General tab.
3. On the Device Information page, the default product name is in the Device Name eld. You can change
this name to uniquely identify this product.
NOTE: Completing the other elds on this page is optional.
4. Click the Apply button to save the changes.
Manually congure IPv4 TCP/IP parameters from the control panel
Use the control-panel Administration menus to manually set an IPv4 address, subnet mask, and default
gateway.
1. Press the Home button on the product control panel.
2. Open the fol
lowing menus:
●
Administration
●
Network Settings
●
Jetdirect Menu
●
TCP/IP
●
IPV 4 Settings
●
Cong Method
3. Select the
Manual option, and then touch the Save button.
4. Open the Manual Settings
menu.
5. Touch the IP Address, Subnet Mask, or Default Gateway option.
6. Touch the
rst eld to open a keypad. Enter the correct digits for the eld, and then touch the OK button.
Repeat the process for each eld, and then touch the Save button.
Manually congure IPv6 TCP/IP parameters from the control panel
Use the control-panel Administration menus to manually set an IPv6 address.
1. Press the Home button on the product control panel.
2. To enable manual conguration, open the following menus:
ENWW Congure IP network settings 69