Security Solutions

stp edged-port
lldp tlv-enable dot1-tlv dcbx
qos trust dot1p
qos wrr be group 1 byte-count 15
qos wrr af1 group 1 byte-count 15
qos wrr af2 group sp
qos wrr af3 group sp
qos wrr af4 group sp
qos wrr ef group sp
qos wrr cs6 group sp
qos wrr cs7 group sp
qos apply policy DCBX outbound
#
Standard FC interface - to change the ethernet port to FC use the
port-type fc command. Supported FC port modes [auto, e, f], auto
is the default mode.
#
interface Fc1/0/11
port access vsan 100
qos trust dot1p
NOTE: FC port speed default is AUTO and fill-word is idle-arbff. For 4Gbps and 2Gpbs, configure
fill-word to idle-idle.
############################################
Configure a Vfc to enable FCoE device login. Supported FCoE port
modes [f,e], f is the default mode, there is no auto mode. A ve port
must be configured using fc mode e.
interface Vfc1
fc mode f
port trunk vsan 100
bind interface Ten-GigabitEthernet1/0/1
#
MAC binding when devices coming from a FIP snooping or standard
DCB device
#
interface Vfc200
port trunk vsan 100
bind interface Bridge-Aggregation1 mac 6c3b-e5af-ad09
#
Setup a Vfc to uplink from NPV switch to FCF or NPV switch
#
interface vfc1000
40 HP FlexFabric 5900CP switch configuration file