HP StorageWorks Fabric OS 3.X Document Addendum (AA-RW24A-TE, January 2005)

Diagnostic and system error messages reference guide

79Fabric OS 3.x Document Addendum

For an unauthorized switch in the SCC policy, add the switch WWN to the SCC policy, using

the secpolicyadd command.

For a certificate retrieve error, make sure the switch certificate is properly installed, using the

pkishow command. Reinstall the certificate, if necessary, using the pkicert command.

For a secret retrieve error, make sure that the secret values are properly set. Reset the secret

values using the secauthsecret command.

For other internal errors (for example, bad payload, incorrect field length, or invalid object),

this might be a transient error. Use the switchdisable and switchenable commands

or portdisable and portenable commands to determine whether the problem is

consistent.

Other errors (for example, invalid nonce, signature, reply message, or response value) might

indicate that an invalid entity is trying to connect to the switch. Check the connection port to

verify that there is no security attack. Otherwise, use the switchdisable and

switchenable commands or portdisable and portenable commands to determine

whether the problem is consistent.

Severity

ERROR

CONFIG-PIDCHANGE_EXTENDED_EDGE

Message

Probable Cause

The PID format for the fabric was changed to Format 2, extended-edge PID. For more

information on PID format, refer to the HP StorageWorks Fabric OS Procedures Version

3.1.x/4.1.x User Guide.

Recommended Action

This message is for information purposes only. The entire fabric must be configured with the

same PID format or the fabric segments.

Severity

WA RN I N G

WARNING CONFIG-PIDCHANGE_EXTENDED_EDGE, 3, Switch PID format changed to

Format 2 ('Extended Edge PID Format').