HP StorageWorks Fabric OS 3.X Document Addendum (AA-RW24A-TE, January 2005)

Diagnostic and system error messages reference guide
112 Fabric OS 3.x Document Addendum
FABRIC-RECONFIG
Message
Probable Cause
The fabric has reconfigured due to an offline port. The reason can be one of the following:
<timestamp>
INFO FABRIC-RECONFIG, 4, fabric: <reason>
Fabric Merge Merging two fabrics
Own ID Rcvd A subordinate switch received an EFP or EFP ACC that has
a payload error, listing this switch as being the principal
switch.
Fabric Segment Principal port became segmented.
Offline Principal port went offline.
Unconfirmed domain Switch was not able to get a domain ID. RDI ACC was
never received.
Rcv BF Received Build Fabric (BF) command.
HA: At F2 State According to the Fibre Channel specification, F2 is defined
as the principal switch selection. If a failover occurs at this
time, the switch is forced to restart principal switch
selection.
HA: No Upstream After failover, the newly active fabric reboots as a
subordinate, but there is no upstream fabric.
HA: bad EFP resp Received an invalid EFP response.
HA: RJT EFP resp Received an EFP reject response in which this EFP was
used for verifying the neighbor's domain list as part of
fabric warm-start recovery. A reject occurs if the neighbor
is reconfiguring or the neighbor's port is in a bad state.
HA: DLST EFP resp Received an EFP accept response with a different domain
list.
HA: PPRI EFP resp Received an EFP accept response in which the response has
a different principal switch priority number.
HA: PWWN EFP resp Received an EFP accept response in which the response has
a different principal switch World Wide Name.
HA: MAX EFP resp An EFP to a neighbor failed to respond, and the fabric
reached its maximum retry count for this neighboring
switch.
HA: Can't Snd EFP Was not able to send an EFP.
HA: Offline A principal port went offline during the fabric daemon's
warm-start recovery.
Principal Selection
Mode
The user has run the fabricprincipal command,
forcing a fabric rebuild.