HP StorageWorks Fabric Manager 5.x Administrator Guide (AA-RUQSF-TE, September 2005)

Fabric Manager 5.x administrator guide 137
Figure 77 Compare/download from file
2. Navigate to the baseline file and click Open.
The Compare/Download from File -- Target Switch Selection window opens.
NOTE: In a Solaris environment, make sure that you select a directory and not the actual file to compare
the configuration against.
3. From the SAN Elements tab, select the switches that you want to compare to the baseline file and move
them to the right-hand window using one of the following methods:
• Select the switch and then click the right arrow.
• Click-and-drag a switch from the SAN Elements tab into the right-hand window.
•Press-and-hold Ctrl, click multiple switches in the SAN Elements tab, and then click the right arrow.
•Press-and-hold Ctrl, click multiple switches, and click-and-drag the switches from the SAN Elements
tab to the right-hand window.
• Click-and-drag a fabric to the right-hand window to add all of the switches in that fabric.
4. Click OK.
The Compare/Download from File -- Switch Configuration comparison and Download window opens
and compares the configurations of the switches to the baseline.
5. Click Apply Baseline to apply this baseline to the switches that you selected.
Comparing switches to a baseline switch
To compare switches to a baseline switch:
1. Select Tools > Configuration > Compare/Download from Switch.
The Compare/Download from Switch -- Source Configuration Selection window opens (see Figure 78).